Tooling and accessories — EMCO Maximat Super 11

Tooling and accessories for the EMCO Maximat Super 11. Lathe tools are kept in the drawers to the left of the lathe. Photos of much of the tooling are in the photo gallery.



Spindle taper

MT4

Tailstock taper

MT2

Chucks

3-jaw Ø140 mm, 4-jaw Ø152 mm, face plate Ø254 mm

ER25 collets (Nov 2015)

3, 4, 5, 6, 8, 10, 12, 14, 15, 16 mm

Drills

15–23 mm

The vertical milling attachment was removed on 1 August 2025.

Chuck stops

Chuck stops for the 3-jaw (top) and 4-jaw (bottom) chucks on their wall holders

Chuck stops for the 3-jaw (top) and 4-jaw (bottom) chucks on their wall holders


3D-printed chuck stops (spacers) sit between the chuck face and the workpiece, so a part sits flat and is clamped at the same depth every time.

  • Sets for both the 3-jaw and the 4-jaw chuck, each in 10, 15 and 20 mm heights. Printed in PETG-CF.

  • Each stop has three N45 neodymium magnets (Ø5 × 5 mm). Put the magnet side against the chuck face so the stop stays in place and flat.

  • Keep them on their wall holders when not in use.

  • They are plastic: don't over-tighten the chuck or push hard with the tailstock against a part resting on a stop. An earlier printed stop cracked in November 2026, probably from exactly that.