429
redigeringar
Redsail Laser - Underhåll: Skillnad mellan sidversioner
ingen redigeringssammanfattning
Daniel (diskussion | bidrag) Ingen redigeringssammanfattning |
Daniel (diskussion | bidrag) Ingen redigeringssammanfattning |
||
| (4 mellanliggande sidversioner av 2 användare visas inte) | |||
| Rad 7: | Rad 7: | ||
==Att göra== | ==Att göra== | ||
* Byta ut alla tre fönster mot nya i kraftigare akryl (5mm eller tjockare), eventuellt i [https://www.plexiglas-shop.com/GB/en/hard-coated-8c0h0k4qcqy/plexiglas-optical-clear-0a000-hc-6smxof3g2cu~p.html hårdbelagd akryl] för att öka reptåligheten? | * Byta ut alla tre fönster mot nya i kraftigare akryl (5mm eller tjockare), eventuellt i [https://www.plexiglas-shop.com/GB/en/hard-coated-8c0h0k4qcqy/plexiglas-optical-clear-0a000-hc-6smxof3g2cu~p.html hårdbelagd akryl] för att öka reptåligheten? | ||
| Rad 94: | Rad 93: | ||
<gallery> | <gallery> | ||
Fil:Lins delar.png | Fil:Lins delar.png|Delarna som sitter i röret | ||
Fil:Linsen ner.png | Fil:Linsen ner.png|Röret med lisen taget sett nedanifrån. Den gängade delen av röret som är mot bilden är där tryckluftsdelen sitter. | ||
Fil:Lins upp.png | Fil:Lins upp.png|Röret med linsen taget sett ovanifrån. | ||
</gallery> | </gallery> | ||
| Rad 160: | Rad 159: | ||
==Logg== | ==Logg== | ||
=== 2025 === | |||
'''2025-02-04:''' Second mirror fixture replaced. Screws that hold the boom tightned. Lens replaced. Mirrors aligned. Filter replaced. | |||
'''2025-01-09:''' Lens replaced, but it's not the correct type. We ran out of the normal ones. Mirrors aligned. | |||
'''2025-01-06:''' Lid for the laser was fixed and strenghted. | |||
===2024=== | ===2024=== | ||
'''2024-12-14:''' Replaced laser head. Greased all the grease nipples except one on the right Y-axis that is not possible to reach. X-axis left pulley assembly was fixed after it broke a few weeks earlier. New bearings for it. New axle and stop to prevent the belt from leaving the pulley was made on the lathe. | '''2024-12-14:''' Replaced laser head. Greased all the grease nipples except one on the right Y-axis that is not possible to reach. X-axis left pulley assembly was fixed after it broke a few weeks earlier. New bearings for it. New axle and stop to prevent the belt from leaving the pulley was made on the lathe. | ||
'''2024-11-20:''' Cleaned mirrors and lens. Replaced filter. Aligned mirrors. | '''2024-11-20:''' Cleaned mirrors and lens. Replaced filter. Aligned mirrors. Laser power was measured to 90W just before the first mirror. | ||
'''2024-09-18:''' Replaced filter. | '''2024-09-18:''' Replaced filter. | ||