115
redigeringar
Cutting Machine Silhouette Cameo Pro MK-II: Skillnad mellan sidversioner
Cutting Machine Silhouette Cameo Pro MK-II (visa wikitext)
Versionen från 4 december 2025 kl. 19.48
, Igår kl. 19.48→Preparing the material feed: tips
Arru (diskussion | bidrag) (heat pen can be used with this machine) |
Arru (diskussion | bidrag) (→Preparing the material feed: tips) |
||
| Rad 34: | Rad 34: | ||
## Mat: remove roll support if needed, ''[mat attachment instructions pending]'' | ## Mat: remove roll support if needed, ''[mat attachment instructions pending]'' | ||
# Adjust the rollers so that the outermost ones sit close to the edge of the foil/mat, and the rest are evenly spaced across | # Adjust the rollers so that the outermost ones sit close to the edge of the foil/mat, and the rest are evenly spaced across. ''If the mat twists as it is loading, check again that the outermost rollers are in a good place.'' | ||
# Push the material up against the intake | # Push the material up against the intake | ||
# Line up your material with the alignment indicator to the left of the intake | # Line up your material with the alignment indicator to the left of the intake | ||