135
redigeringar
Cutting Machine Silhouette Curio 2: Skillnad mellan sidversioner
Cutting Machine Silhouette Curio 2 (visa wikitext)
Versionen från 27 december 2025 kl. 11.02
, 27 december 2025move table to software section
Arru (diskussion | bidrag) m (style settings table) |
Arru (diskussion | bidrag) (move table to software section) |
||
| Rad 164: | Rad 164: | ||
# rub and press to make the piece and the box stick well to the surface. | # rub and press to make the piece and the box stick well to the surface. | ||
# If it does not feel completely fixed, use some masking tape to hold it in place, avoiding the parts that are going to have foil applied to them | # If it does not feel completely fixed, use some masking tape to hold it in place, avoiding the parts that are going to have foil applied to them | ||
=== Software set-up === | === Software set-up === | ||
{| class="wikitable", style="clear: right; float: right; width: 20em; padding: 0.3em" | |||
|+ | |||
!Foil setting | |||
!Acrylic | |||
|- | |||
|Speed | |||
|4 | |||
|- | |||
|Pressure | |||
|12 | |||
|- | |||
|Line raster (2,5 mm pen / 100% fill) | |||
|0,2mm | |||
|} | |||
Heat pen will take > 5 minutes to warm up. By doing the software part first, you get the opportunity to start the heating in advance and have it ready when all setup is finished. | Heat pen will take > 5 minutes to warm up. By doing the software part first, you get the opportunity to start the heating in advance and have it ready when all setup is finished. | ||
| Rad 183: | Rad 199: | ||
## For a 100% fill, use hatch (lines) fill style with setting from the table | ## For a 100% fill, use hatch (lines) fill style with setting from the table | ||
=== Material set-up === | === Material set-up === | ||