Spånsug, Felder RL 125

Generell information

The Felder RL 125 is a powerfull chip extractor connected to most of the machines in the woodshop. A sound absorber was added on top of the machine to keep the noise level acceptable. A combination of 100mm fixed pipes and flexible hoses with doors are used to direct the suction to the desired machine.

To use the vacuum, start the machine by turning the red knob and open the desired door connecting to the machine you are using. Check before starting it that all the other doors are closed in order to get the most flow. In a near futur, the vacuum will turn ON and OFF automatically when opening/closing the doors.

The vacuum should be used at anytime with the following machines:

- Table saw, table router and planer with the flexible hose. Use as well to clean around the miter saw and the lathe.

- Band saw (one dedicated flexible hose)

- Miter saw (two dedicated pipes)

In a near futur, the belt sander and drill press will have a dedicated hose too.

Near the belt sander, a pipe goes all the way to the floor and make the floor cleaning really easy.

Säkerhetsinformation

Saker man bör tänka på när man använder maskinen för att inte skada sig, andra, eller maskinen

Not much risks of injuring yourself, but a few things to keep in mind to keep the machine running safely:

- Do not cut or sand any wet wood as you could clog the filter (which is an expensive spare part)

- Check the level of dust in the bag and change the bag when reaching the maximum level.

- On the side of the machine, there is a handle that you can pull a few times to clean the filter, do not perform this when the machine is running.

- Do not obstruct the air output.

Handhavande av maskinen

Manual

Manual pa Felder RL

Material

Endast för trä!

Användarinstruktioner

Se till att koppla in dammsugare innan du använder den!

Skriv något om hur man ställer de olika vinklarna

Förbrukningsmaterial

Köpa verktyg

Var man kan köpa verktyg för att använda i maskinen för att bearbeta ämnen. T.ex. svarvstål till svarven, pinnsfräsar till fräsen.

Klingdiameter: 216 mm

Klinghåls-Ø: 30 mm

Reservdelar

Har vi reservdelar på plats?

Logg

2019-12-XX: Inköpt

Länkar

https://www.bosch-professional.com/se/sv/products/gcm-8-sjl-0601B19100

Ägare

Maskinen inköpt av Makerspace 2019-08-05

Gallery

Starting switch and handle for cleaning the filter