1
redigering
Plan- och rikthyvel, Scheppach HMC 3200: Skillnad mellan sidversioner
Plan- och rikthyvel, Scheppach HMC 3200 (visa wikitext)
Versionen från 20 januari 2026 kl. 21.00
, 20 januarijust wording errors
Henningk (diskussion | bidrag) Ingen redigeringssammanfattning Märken: Mobilredigering Mobil webbredigering |
m (just wording errors) |
||
| (4 mellanliggande sidversioner av 2 användare visas inte) | |||
| Rad 16: | Rad 16: | ||
|- | |- | ||
|} | |} | ||
==Generell information== | ==Generell information== | ||
'''<big>The use of pallet wood, reclaimed flooring, reclaimed outdoor deck planks and any kind of wood used for concrete formwork is totally forbidden.</big>''' | '''<big>The use of pallet wood, reclaimed flooring, reclaimed outdoor deck planks and any kind of wood used for concrete formwork is totally forbidden.</big>''' | ||
| Rad 72: | Rad 71: | ||
===Material=== | ===Material=== | ||
Endast för trä! Only for wood! | Endast för trä! Only for wood! Don't use wet or green wood. Wait 24 hours before planing glued wood pieces or pieces with epoxy. | ||
Use only clean (without nails, screws or sand particles) wood. No other material allowed. | Use only clean (without nails, screws or sand particles) wood. No other material allowed. | ||
| Rad 80: | Rad 79: | ||
The new spiral cutterhead uses 15mmx15mmx2.5mm-R150 carbide inserts. We have a set of 10 spare. | The new spiral cutterhead uses 15mmx15mmx2.5mm-R150 carbide inserts. We have a set of 10 spare. | ||
The inserts can be rotated 3 times before being replaced. The recommended torque range is 5.4-5.9 Nm (48-52 pound inch). | The inserts can be rotated 3 times before being replaced. The recommended torque range is 5.4-5.9 Nm (48-52 pound inch). | ||
==Underhåll och reservdelar== | ==Underhåll och reservdelar== | ||
| Rad 109: | Rad 106: | ||
==Logg== | ==Logg== | ||
*2025-01-05: rotated cutting steels on cutterhead (counter clockwise). Some were already rotated, they were left as is in order to get consistency in the orientation of the marker (unrotated marked with permanent marker. (Test runs gave good results.) Images of markings: [[Media:Planer-IMG20250105130022.jpg]] [[Media:Planer-IMG20250105130039.jpg]] [[Media:Planer-IMG20250105130048.jpg]] [[Media:Planer-IMG20250105130059.jpg]] [[Media:Planer-IMG20250105130116.jpg]] | |||
*2025-01-02: aluminium gears dead. New ones (including drive chains) ordered. | |||
*2022-02-16: installed the new spiral cutterhead with new bearings. | *2022-02-16: installed the new spiral cutterhead with new bearings. | ||
*2021-06-01: replaced two needle bearings on the plastic gear in the autofeed mechanism. | *2021-06-01: replaced two needle bearings on the plastic gear in the autofeed mechanism. | ||