259
redigeringar
Bordssåg, Hammer K3 Winner: Skillnad mellan sidversioner
Bordssåg, Hammer K3 Winner (visa wikitext)
Versionen från 22 november 2024 kl. 12.10
, 22 november 2024→Säkerhetsinformation
Voxel (diskussion | bidrag) (Add course info) |
Voxel (diskussion | bidrag) |
||
| Rad 39: | Rad 39: | ||
*'''Never cut stock free hand''' | *'''Never cut stock free hand''' | ||
*Be certain that the blade is sharp | *Be certain that the blade is sharp | ||
*Set the blade so that it extends no more | *Set the blade so that it extends no more than 10 mm above the stock to be cut | ||
*Stand to one side of the operation blade, do not reach across it | *Stand to one side of the operation blade, do not reach across it | ||
*Make sure that the stock is fully past the blade before turning the saw off | *Make sure that the stock is fully past the blade before turning the saw off | ||
| Rad 46: | Rad 46: | ||
*Use only new stock that is free of knots, splits and warp | *Use only new stock that is free of knots, splits and warp | ||
*Use a push stick to push small scrap away | *Use a push stick to push small scrap away | ||
*Cross cutting on the table saw is dangerous. 30 cm cross cuts or under should be made on the BOSCH sliding compound miter saw | *Cross cutting on the table saw is dangerous. 30 cm cross-cuts or under should be made on the BOSCH sliding compound miter saw | ||
*As you complete your work, turn off the saw and remain until the blade has stopped | *As you complete your work, turn off the saw and remain until the blade has stopped | ||
*Clear the saw of dust and waste. Return the saw blade to zero settings. Sweep the work area! | *Clear the saw of dust and waste. Return the saw blade to zero settings. Sweep the work area! | ||