Skillnad mellan versioner av "Plan- och rikthyvel, Scheppach EMC 3200"

Från Stockholm Makerspace Wiki
Hoppa till navigering Hoppa till sök
(Handhavande av maskinen)
Rad 79: Rad 79:
*2020-02-XX: Miter saw station build next to the dust collector.
*2020-01-XX: dust collector built for the planer
*2019-10-05: Inköpt
*20XX: Inköpt

Versionen från 25 februari 2020 kl. 23.37

Snabbfakta Bosch GCM8 SJL
Scheppach hmc 3200.jpg
Modell: Scheppach HMC 3200
Bokningsbar: Nej
Kostnad att använda: Gratis
Info 1: Kap- och gersåg
Arbetsyta: 32 cm
Obelastad hastighet: - RPM
Märkeffekt: - W

Generell information


  • Wear safety glasses, keep hands at least 15 cm from the cutterhead
  • Make adjustments with the machine powered off
  • Check planer table before turning it on, a tool might have slipped under the cutter head
  • Stock must be at least 30 cm long. Minimum 6 mm thick for jointer, 4 mm for planning
  • Blades must be sharp. Dull blades will vibrate the stock and may cause a kickback.
  • Clean tool and work area when done
  • Feed the work so that the knives will cut “with the grain”. Use only stock that is free of knots and splits. Do not plane end grain
  • Use a push block when planing a flat surface. Never apply pressure directly over the knives with your hand.
  • Do not plane the maximum amount off of stock when planing. Two passes through the planer can be better than one.
  • When planning thin pieces of wood, be sure to stand to one side in case the wood breaks and kicks back.
  • Support the work properly at the in feed and at the out feed.

Handhavande av maskinen


Sprängskiss: Fil:Scheppach hmc 3200 planing combi.pdf


Endast för trä! Do to use wet or green wood. Wait 24 hours before planing glued wood pieces or pieces with epoxy.

Use only clean (without nails, screws or sand particles) wood. No other material allowed.


Se till att koppla in dammsugare innan du använder den!

Skriv något om hur man ställer de olika vinklarna


We currently have 3 sets of blades. Label and store the dull blades. When two sets are dull, send them to resharpening.

Underhåll och reservdelar


  • Daily
    • Visual check whether unit or parts are damaged
    • Check whether power cable is damaged
    • Check if there is any parts loose around the blades before plugging and running it.
  • Monthly
    • Check the blade sharpness. Change blade if necessary.
  • Annually
    • Remove the front cover to clean and grease the transmission chain and clean the clutch plates.
  • TODO


We do not have spare parts for this machine.


  • 2020-01-XX: dust collector built for the planer
  • 20XX: Inköpt


8 Miter Saw Pro Tips & Tricks - Steve Ramsey - Woodworking for Mere Mortals


Maskinen inköpt av Makerspace


Ritningsförslag på rikthyvel:Fil:Rikthyvel.pdf

Sprängskiss: Fil:Scheppach hmc 3200 planing combi.pdf