Bordssåg, Meec MJ2325B: Skillnad mellan sidversioner

Bordssåg, Meec MJ2325B (visa wikitext)

Versionen från 25 februari 2020 kl. 23.49

83 byte lades till , 25 februari 2020

→‎Säkerhetsinformation

VisuellWikitext

Cloraux

166

redigeringar

@@ Rad 32: / Rad 32: @@
 ==Säkerhetsinformation==
-*Wear safety glasses, keep hands at least 15 cm from the cutterhead
+*Wear safety glasses and turn on the dust extractor
-*Make adjustments with the machine powered off
+*The Riving Knife is the most important safety feature and may not be removed
-*Check planer table before turning it on, a tool might have slipped under the cutter head
+*Be certain that the blade is sharp and that it is the right blade for your work
-*Stock must be at least 30 cm long. Minimum 6 mm thick for jointer, 4 mm for planning
+*Set the blade so that it extends no more that 5 mm above the stock to be cut
-*Blades must be sharp. Dull blades will vibrate the stock and may cause a kickback.
+*Stand to one side of the operation blade, do not reach across it
-*Clean tool and work area when done
+*Make sure that the stock is fully past the blade before turning the saw off
-*Feed the work so that the knives will cut “with the grain”. Use only stock that is free of knots and splits. Do not plane end grain
+*Keep hands at least 15 cm from the blade. Use push sticks when cutting closer
-*Use a push block when planing a flat surface. Never apply pressure directly over the knives with your hand.
+*Rough stock must be surfaced and at least one side jointed before being cut
-*Do not plane the maximum amount off of stock when planing. Two passes through the planer can be better than one.
+*Never cut stock free hand
-*When planning thin pieces of wood, be sure to stand to one side in case the wood breaks and kicks back.
+*Use only new stock that is free of knots, splits and warp
-*Support the work properly at the in feed and at the out feed.
+*Use a push stick to push small scrap away
+*Cross cutting on the table saw is dangerous. 30 cm cross cuts or under should be made on the BOSCH sliding compound miter saw
+*As you complete your work, turn off the saw and remain until the blade has stopped
+"Clear the saw of dust and waste. Return the saw blade to zero settings. Sweep the work area!
 ==Handhavande av maskinen==