Hoppa till innehållet

Plan- och rikthyvel, Scheppach HMC 3200: Skillnad mellan sidversioner

Rad 19: Rad 19:


==Generell information==
==Generell information==
<br />
'''<big>The use of pallet wood, reclaimed flooring, reclaimed outdoor deck planks and any king of wood used for concrete formwork is totally forbidden.</big>'''
 
Before jointing or planing, the boards should be inspected for nails, screws or any metallic chips.
 
Wood planks must be cleaned with a hard brush to remove sand dust. <br />
==Säkerhetsinformation==
==Säkerhetsinformation==


Rad 43: Rad 47:


Use only clean (without nails, screws or sand particles) wood. No other material allowed.   
Use only clean (without nails, screws or sand particles) wood. No other material allowed.   
'''<big>The use of pallet wood, reclaimed flooring, reclaimed outdoor deck planks and any king of wood used for concrete formwork is totally forbidden.</big>''' 
===Användarinstruktioner===
===Användarinstruktioner===
Se till att koppla in dammsugare innan du använder den!
Se till att koppla in dammsugare innan du använder den!


==Förbrukningsmaterial==
==Förbrukningsmaterial==
We currently have 3 sets of blades. Label and store the dull blades. When two sets are dull, send them to resharpening.  
The new spiral cutterhead uses 15mmx15mmx2.5mm-R150 carbide inserts. We have a set of 10 spare. 
 
The inserts can be rotated 3 times before being replaced. The recommended torque range is 5.4-5.9 Nm (48-52 pound inch). 
 
<s>We currently have 3 sets of blades. Label and store the dull blades. When two sets are dull, send them to resharpening.</s>


==Underhåll och reservdelar==
==Underhåll och reservdelar==
Rad 72: Rad 82:
==Logg==
==Logg==


*2022-02-16: installed the new spiral cutterhead with new bearings.
*2021-06-01: replaced two needle bearings on the plastic gear in the autofeed mechanism.
*2021-06-01: replaced two needle bearings on the plastic gear in the autofeed mechanism.
*2021-01-xx: new motor and new motor protection. Some gears of the autofeed mechanism replaced.
*2021-01-xx: new motor and new motor protection. Some gears of the autofeed mechanism replaced.
166

redigeringar