Cutting Machine Silhouette Curio 2: Skillnad mellan sidversioner

Cutting Machine Silhouette Curio 2 (visa wikitext)

355 byte lades till , 18 november

→‎Pen plotting: pen adapter instrs

115

redigeringar

@@ Rad 85: / Rad 85: @@
 #*# [[Fil:Silhouette standard Pen holder assembly.jpg|ingen|miniatyr|150x150px|Insert pen into holder]][[Fil:Pen holder mounted.jpg|ingen|miniatyr|200x200px|Mount pen holder to cutter just like a blade tool]]
 #* Custom pen ("C" adapter)
-#*# Try out the 3 adapter rings to see which one fits your pen the most snugly
+#*# Try out the 3 colored adapter rings to see which one fits your pen the most snugly
-#*# Insert pen into the white bottom part. The pen tip must reach through the bottom hole.
+#*# Insert pen into the white bottom part and screw the adapter into it
-#*# Screw the adapter onto the base, pen should not be able to move at all
+#*# The pen tip must reach out of the bottom hole at just the correct distance.
-#*# Mount pen in tool position 1 just like a cutting tool
+#*## Push the pen as far as it will go out of the white holder
+#*## Attach the transparent pen holder cap, pushing the pen back in until the cap is fully in place
+#*## Check that the pen tip sits centered in the cap
+#*# Screw on the white top adapter ring, gentle fingers as it is prone to breaking
+#*# Check that there is no play (wiggle) in the pen
+#*# Mount pen assembly in tool position 2, just like a cutting tool
 #*# ''TODO: list of known pen types that fit one of the adapters''
 # Perform the same steps in Silhouette studio as for cutting, selecting "Pen holder", suitable material, and "Sketch" instead of Cut.