1
redigering
Cutting Machine Silhouette Cameo Pro MK-II: Skillnad mellan sidversioner
Cutting Machine Silhouette Cameo Pro MK-II (visa wikitext)
Versionen från 4 mars 2026 kl. 16.49
, 4 mars→Software preparation: Namnet matchar det i programmet nu
Arru (diskussion | bidrag) (heat pen can be used with this machine) |
(→Software preparation: Namnet matchar det i programmet nu) Märken: Mobilredigering Mobil webbredigering |
||
| (En mellanliggande sidversion av en annan användare visas inte) | |||
| Rad 34: | Rad 34: | ||
## Mat: remove roll support if needed, ''[mat attachment instructions pending]'' | ## Mat: remove roll support if needed, ''[mat attachment instructions pending]'' | ||
# Adjust the rollers so that the outermost ones sit close to the edge of the foil/mat, and the rest are evenly spaced across | # Adjust the rollers so that the outermost ones sit close to the edge of the foil/mat, and the rest are evenly spaced across. ''If the mat twists as it is loading, check again that the outermost rollers are in a good place.'' | ||
# Push the material up against the intake | # Push the material up against the intake | ||
# Line up your material with the alignment indicator to the left of the intake | # Line up your material with the alignment indicator to the left of the intake | ||
| Rad 45: | Rad 45: | ||
=== Software preparation === | === Software preparation === | ||
# Start ''Silhouette Studio'' on the computer next to the cutting machines. | # Start ''Silhouette Studio'' on the computer next to the cutting machines. | ||
# Select Cameo Pro | # Select Cameo Pro Mark 2 in the top right white box. It should say "ready" in green letters, if not, check that it's | ||
## Turned on | ## Turned on | ||
## Connected via USB | ## Connected via USB | ||