22
redigeringar
DanielS (diskussion | bidrag) |
DanielS (diskussion | bidrag) Ingen redigeringssammanfattning |
||
Rad 86: | Rad 86: | ||
|2013-09-15 | |2013-09-15 | ||
|Around 5-10 of the funders gather to put the printer into operation. Instructions from the seller (Markus) were followed on how to unpack it: zip ties are removed, sewing machine oil is applied to XY rods and XY gantry and the Z screw is greased. | |Around 5-10 of the funders gather to put the printer into operation. Instructions from the seller (Markus) were followed on how to unpack it: zip ties are removed, sewing machine oil is applied to XY rods and XY gantry and the Z screw is greased. | ||
White filament on a big roll marked ”ABS reprap gmbh” that was included in the received package was mounted and fed into the Bowden tube / hotend. It is very finicky to get the filament into the entry of the Bowden tube (needs to be improved) The ulticontroller was used to heat up the hotend. We got plastic out at around 240 degrees Celsius, but before this the temperature was manually turned up to about 270 degrees (the default ”preheat” profiles for both PLA and ABS had been set to 292 degrees Celsius. We should ask Markus about why this is pre-set to such a high temperature. Is the temperature probe off by chance? Or is he printing with higher-temp materials as well?. | White filament on a big roll marked ”ABS reprap gmbh” that was included in the received package was mounted and fed into the Bowden tube / hotend. It is very finicky to get the filament into the entry of the Bowden tube ('''needs to be improved''') The ulticontroller was used to heat up the hotend. We got plastic out at around 240 degrees Celsius, but before this the temperature was manually turned up to about 270 degrees (the default ”preheat” profiles for both PLA and ABS had been set to '''292 degrees Celsius. We should ask Markus about why this is pre-set to such a high temperature. Is the temperature probe off by chance? Or is he printing with higher-temp materials as well?'''. | ||
We fired up Cura and saved the existing configuration that was for the reprap Huxley on the Desktop of the ”3D Printer laptop”. | We fired up Cura and saved the existing configuration that was for the reprap Huxley on the Desktop of the ”3D Printer laptop”. | ||
We ran the ”first run wizard” so that Cura can perform some self calibration and have correct ”default settings”. We changed the nozzle size to 0.5 (not knowing that it is most likely 0.6 or 0.7mm nozzles that has been delivered). | We ran the ”first run wizard” so that Cura can perform some self calibration and have correct ”default settings”. We changed the nozzle size to 0.5 (not knowing that it is most likely 0.6 or 0.7mm nozzles that has been delivered). |
redigeringar