135
redigeringar
Cutting Machine Silhouette Curio 2: Skillnad mellan sidversioner
Cutting Machine Silhouette Curio 2 (visa wikitext)
Versionen från 27 december 2025 kl. 11.43
, 27 december 2025→Foil application: check heating
Arru (diskussion | bidrag) (→Positioning in Curio cutter: move mat instructions to software section) |
Arru (diskussion | bidrag) (→Foil application: check heating) |
||
| Rad 209: | Rad 209: | ||
=== Foil application === | === Foil application === | ||
# Double check that the pen has finished heating up (thermometer on button is all red, not animating) | |||
# press "Send" to start foil transfer | # press "Send" to start foil transfer | ||
# pay attention to whether the pen hits the surface and the thickness was correctly detected. If not, make sure you are using the trick with a "reference piece" of opaque acrylic at the 0,0 point, see above | # pay attention to whether the pen hits the surface and the thickness was correctly detected. If not, make sure you are using the trick with a "reference piece" of opaque acrylic at the 0,0 point, see above | ||