Cutting Machine Silhouette Curio 2: Skillnad mellan sidversioner

Cutting Machine Silhouette Curio 2 (visa wikitext)

Versionen från 27 december 2025 kl. 11.51

92 byte lades till , 27 december 2025

→‎Heat foil instructions: separate section for pen heating

VisuellWikitext

Arru

135

redigeringar

@@ Rad 152: / Rad 152: @@
 # Take both pieces over to the Curio
+=== Pen warm-up ===
+Heat pen will take 5-10 minutes to warm up. Starting the warm-up first thing, it'll be ready for use by the time you've finished the rest of the preparations.
+# open your design in Silhouette software
+# go to send tab
+# choose ”acrylic, foil” material preset
+# Insert 2,5mm heat pen into slot 2
+# Start pen heating by clicking thermometer button in the silhouette Send tab
 === Positioning in Curio cutter ===
 [[Fil:Rigging for thickness detection.jpg|miniatyr|Foil application setup for acrylic, ready to start, with an extra piece at 0,0 position to guide the thickness detector.]]
@@ Rad 165: / Rad 172: @@
 # rub and press to make the piece and the box stick well to the surface.
 # If it does not feel completely fixed, use some masking tape to hold it in place, avoiding the parts that are going to have foil applied to them
 === Software set-up ===
 {| class="wikitable", style="clear: right; float: right; width: 20em; padding: 0.3em"
@@ Rad 182: / Rad 187: @@
 |0,2mm
 |}
-Heat pen will take > 5 minutes to warm up. By doing the software part first, you get the opportunity to start the heating in advance and have it ready when all setup is finished.
 # open your design in Silhouette software
-# go to send tab
+# make sure pen heating is on per instructions above
-# choose ”acrylic, foil” material preset
-# Insert 2,5mm heat pen into slot 2
-# Start pen heating by clicking thermometer button in the silhouette Send tab
 # choose ”cut by color” mode
 # Go to Design tab