Cutting Machine Silhouette Curio 2: Skillnad mellan sidversioner

Cutting Machine Silhouette Curio 2 (visa wikitext)

70 byte lades till , 27 december 2025

143

redigeringar

@@ Rad 133: / Rad 133: @@
 * Press the ⏸️ button in the control panel (only lit while cutting)
 * To cancel cutting completely:
-*# Long press the pause button again for ≈ 10 seconds
+*# Long press the ⏸️ button again for ≈ 10 seconds, the sled will return to the rear left starting position
 *# Find the cut job listed next to the Send button in Silhouette studio. Press close ╳ next to the cut job.
 * To resume, press ⏸️ button again
@@ Rad 203: / Rad 203: @@
 # wipe the acrylic surface with isopropyl alcohol so that it is squeaky clean
 # measure a suitable length of heat transfer foil to cover the areas with the design. Make room on the sides of the actual design for attaching tape, foil transfer does not work well with tape on top
-# cut it using the best pair of scissors you can find as the foil is very delicate
+# find the best pair of scissors on hand – the foil is very delicate
-# roll foil onto piece + jig, use squegee (part of the cutter tools on the wall) to wipe the foil all flush against the surface
+# cut the foil to length
-# apply masking tape at the edges, gently pulling to get the foil flat agains the surface
+# roll foil onto piece + jig, use squegee (among the cutter tools on the wall) to wipe the foil all flush against the surface
+# apply masking tape at the edges, gently pulling to get the foil flat against the surface
 === Foil transfer ===