166
redigeringar
Cloraux (diskussion | bidrag) |
Cloraux (diskussion | bidrag) |
||
Rad 19: | Rad 19: | ||
==Generell information== | ==Generell information== | ||
<br /> | '''<big>The use of pallet wood, reclaimed flooring, reclaimed outdoor deck planks and any king of wood used for concrete formwork is totally forbidden.</big>''' | ||
Before jointing or planing, the boards should be inspected for nails, screws or any metallic chips. | |||
Wood planks must be cleaned with a hard brush to remove sand dust. <br /> | |||
==Säkerhetsinformation== | ==Säkerhetsinformation== | ||
Rad 43: | Rad 47: | ||
Use only clean (without nails, screws or sand particles) wood. No other material allowed. | Use only clean (without nails, screws or sand particles) wood. No other material allowed. | ||
'''<big>The use of pallet wood, reclaimed flooring, reclaimed outdoor deck planks and any king of wood used for concrete formwork is totally forbidden.</big>''' | |||
===Användarinstruktioner=== | ===Användarinstruktioner=== | ||
Se till att koppla in dammsugare innan du använder den! | Se till att koppla in dammsugare innan du använder den! | ||
==Förbrukningsmaterial== | ==Förbrukningsmaterial== | ||
We currently have 3 sets of blades. Label and store the dull blades. When two sets are dull, send them to resharpening. | The new spiral cutterhead uses 15mmx15mmx2.5mm-R150 carbide inserts. We have a set of 10 spare. | ||
The inserts can be rotated 3 times before being replaced. The recommended torque range is 5.4-5.9 Nm (48-52 pound inch). | |||
<s>We currently have 3 sets of blades. Label and store the dull blades. When two sets are dull, send them to resharpening.</s> | |||
==Underhåll och reservdelar== | ==Underhåll och reservdelar== | ||
Rad 72: | Rad 82: | ||
==Logg== | ==Logg== | ||
*2022-02-16: installed the new spiral cutterhead with new bearings. | |||
*2021-06-01: replaced two needle bearings on the plastic gear in the autofeed mechanism. | *2021-06-01: replaced two needle bearings on the plastic gear in the autofeed mechanism. | ||
*2021-01-xx: new motor and new motor protection. Some gears of the autofeed mechanism replaced. | *2021-01-xx: new motor and new motor protection. Some gears of the autofeed mechanism replaced. |
redigeringar