22
redigeringar
AndOr (diskussion | bidrag) (Print settings) |
AndOr (diskussion | bidrag) (Added troubleshooting) |
||
Rad 93: | Rad 93: | ||
=== Andreas first prints 2013-11-26 === | === Andreas first prints 2013-11-26 === | ||
Used Cura 13.11 (on my laptop) and printed two small (~4x4x2 & ~8x5x2 cm) gingerbread cutters. Very happy with my first print on this machine, except maybe retraction so a few strings had to be cut off afterwards. | Used Cura 13.11 (on my laptop) and printed two small (~4x4x2 & ~8x5x2 cm) gingerbread cutters with 3dverkstan PLA filament. Very happy with my first print on this machine, except maybe retraction so a few strings had to be cut off afterwards. | ||
* Basic: Layer height=0.2, Shell thickness=0.8, Enable retraction=Y, Botton/Top fill=0.4, Fill density=30%, Print speed=50mm/s, Print temperature=210, Bed temperature=60, Support=None, Platform adhesion type=Brim, Filament diameter=2.85, Flow=100% | * Basic: Layer height=0.2, Shell thickness=0.8, Enable retraction=Y, Botton/Top fill=0.4, Fill density=30%, Print speed=50mm/s, Print temperature=210, Bed temperature=60, Support=None, Platform adhesion type=Brim, Filament diameter=2.85, Flow=100% | ||
Rad 99: | Rad 99: | ||
* Start g-code: http://pastebin.com/SYAEtuP9 | * Start g-code: http://pastebin.com/SYAEtuP9 | ||
* End g-code: http://pastebin.com/urSF5dci | * End g-code: http://pastebin.com/urSF5dci | ||
== Troubleshooting == | |||
Hints from Daniel S: | |||
* The biggest risk for getting a big jam in the extruder is keep the extruder warn too long without running. Then the heat can spread upward and make a blockage. | |||
* When changing between ABS and PLA you need to make sure to remove all ABS-remains to avoid jamming. Some manual extruding may be necessary. The easiest would be to have two 3d printers: one for PLA and one for ABS. | |||
Also see: | |||
* http://wiki.ultimaker.com/Troubleshooting | |||
* http://wiki.ultimaker.com/Jamming | |||
== Change Log == | == Change Log == |
redigeringar