15
redigeringar
Carvera Air: Skillnad mellan sidversioner
ingen redigeringssammanfattning
Prakash (diskussion | bidrag) mIngen redigeringssammanfattning |
Prakash (diskussion | bidrag) Ingen redigeringssammanfattning |
||
| Rad 19: | Rad 19: | ||
= How to use = | = How to use = | ||
The following steps assumes you have prepared your Gcode from your favorite CAM software. | |||
As an alternative, you can also use Makera CAM software. The steps are described here <<TODO>> | |||
== Prepare your GCode == | |||
'''- Please refer this page for adding Carvera profile and post processor in Fusion 360, VCarve Desktop'''<gallery> | |||
Fil:Controller.png | |||
</gallery>https://github.com/MakeraInc/CarveraProfiles | |||
== Install Controller software == | |||
The Controller software for Carvera Air will most likely be installed on a common computer or a tablet that is attached to the device. Until then or If you prefer to have it installed on your own computer, you can do so from https://github.com/MakeraInc/CarveraController | |||
== Upload your GCode to Carvera Air == | |||
[[Fil:Controller.png|miniatyr]] | |||
- Launch Carvera Controller software | |||
- If you are running for first time, you will need to search the machine name in WiFi. When you search, you will find it with the name Makerspace_CarveraAir | |||
- Select the icon on the bottom left | |||
- Browse and select your nc file | |||
- Upload | |||
- Close the dialog and select your nc file | |||
- Install controller software | |||
- Upload them to network drive.. <<location>> | |||
- Launch Carvera Controller software | |||
- Screenshots | |||