Jigs for woodworking
The machine's own course and rules apply. Get instruction on the jig before using it. Old table saw jigs were made for the previous saw and may not fit the Hammer K3.
Shared jigs for woodworking. Inspect before use, keep hardware together and return them to their place.
Where to find them
Jig | For | Location |
|---|---|---|
Wolfcraft dowel jig | Drilling dowel holes | Drawers under the belt sander |
MaKoen circle jig | Circles with the Festool OF 1010 | Wall holder, with its screw bag |
Clas Ohlson dovetail jig (30-4751 / 91800) | Dovetails with a handheld router | Blue fixture |
Enjoywood 700 mm fence with flip stops | Below the router table | |
Enjoywood coping sled | Router table (front rail) | Wall, beside the torque wrenches |
Homemade finger-joint jig | Router table | Under the Sjöberg workbench |
Thin-strip carrier "JIG #1 / THIN STRIP JIG / FOR PLANER" | Wall |
Also available: biscuit joiner. There is no Domino.
MaKoen circle jig
Unplug the router. Mount using the OF 1010 EBQ hole pattern, manual p. 18. Keep the removed sole-plate screws in the bag and refit them afterwards.
The scale reads cutter centre to pivot centre:
Opening: radius − cutter radius
Disc: radius + cutter radius
Clamp the work and pivot, both hands on the router, feed against the rotation, shallow passes. Keep the cutter clear of clamps and bench.
MaKoen circle jig on its wall holder with screw bag
Dovetail jig
For a handheld router. Use a dovetail cutter with a ½" (12.7 mm) guide bearing and 6 mm shank.
The 30 mm copying ring is not a substitute for the bearing.
Clamp the jig to a bench and test on scrap. The English and Swedish manuals give different thickness specs — check the setup.
Blue Clas Ohlson dovetail jig
Router table accessories
Fit only with black main power OFF and the cutter stopped. Clamp the work and check clearance over the full travel. See the router table page.
Coping sled in the front rail
Coping sled on the wall
Finger-joint jig: homemade, for the router table. Get instruction on the cutter, indexing and clamping first.
Homemade finger-joint jig parts
Planer thin-strip carrier
Doesn't override the planer's minimum stock size, feed or safety rules. Get the setup checked before running thin veneer.
Old table saw jigs
Made for the previous table saw. The two-slot crosscut sled doesn't fit the Hammer without adaptation. Before using any of these, have the fit, guard and riving-knife clearance checked. Never remove the riving knife or use a dado stack.
Jig | Purpose |
|---|---|
Crosscut sled | Slides in the table slots; holds work against a fence for square cuts |
Mitre sled attachment | Angled cuts |
Thin-strip jig | Repeated thin rips without resetting the fence |
Spline jig | Cuts slots across mitre corners for splines; sits on a sled with a cradle and adjustable fence |
Box joint jig | Finger joints; 6 × 6 mm indexing key |
For blade height, length stops and crosscutting rules, follow the table saw page.
Care
Clean after use without damaging reference faces. Report cracks, loose fasteners, damaged guides or missing hardware in #trärummet-woodroom. Don't alter shared stops, geometry or mounting holes.